Friday, May 23, 2014

More grinding

With the hull flipped over it was time to look for spots where the core wasn't fully bonded to the hull. As I suspected the very back where the previous repair job was done didn't bond well. 

I'll be grinding out a 2'x3' section and reglassing. 


Sunday, May 11, 2014

Flip it

Boat is flipped over. My back is broken. 
Back to sanding and glassing. 

Sunday, April 27, 2014

Boat Cart


This will slide under the tunnel and allow me to roll the boat hull outside. 

Built from stuff laying around the garage rather than going out and buying a could floor jacks. 

Sunday, April 6, 2014

Long time no post

Kitchen and living room have consumed all my time. I'll be back at it soon. 

My plan to use Awlgrip isn't going to happen. Instead I'm using Imaron. 

More in that later. 

In the mean time...

Sunday, January 26, 2014

Stalled

Kitchen / first floor remodel has boat progress dead in the water. 

I did check out a couple jet boats while my friend was looking at a motor for his car. 









Thursday, December 26, 2013

Glassed

The majority of the glass work is complete!

Best part? I can walk around in the hull to work on stuff now! Stretching to get to the middle of the hull has destroyed my lower back. 

There's a few places where there's bubbles and dry spots I need to patch up but she's water tight and stuff as a board now. 

I'm working on some transome knees to hold the fuel tank in place and add some structural support. 




Also my son dropped his stuffed animal in the toilet: